KITACO is a brand that releases a wide variety of items mainly of 4MINI parts. They release many products essential for exhaust gasket and others of almost all vehicles.
 |  |  |
| | | |
 |  |  |
| | | |
 |  |  |
| | | |
 | ||
| |
I purchased this product when I was looking for Exhaust System replacement. This is a long time old product so there is no problem and I use it normally. It is not such an expensive item, so I will re...
It is used to receive the Fuel Tank's Breather Hose 650mm 6mm Diameter. You can see the inside of the hose inside and it is Compact so you can install it anywhere. It doesn't matter how you install it...
Off cars are recommended to switch from OEM Product to this immediately.It is convenient for Large because it can be installed with Tie Wrap instead of Bolt stopper.Wiring is also recommended to the b...
I installed them because I chose the Fender Eliminator Spec. The installation is possible to fix by Bolt&Nut and the brightness is bright enough, so I think it will pass the inspection without any pro...
I opted for the General Belts because I was informed that the Reinforced Belts are difficult to predict and can suddenly cut off.However, I was worried about the unknown ones, so I bought the well-kno...
Emon's Bullet Terminal (Male) When I tried to connect with the Bullet Terminal of this product (Female) Because the Size of "Size" was a little too small to fit, I changed to Bullet Terminal of Emon.I...
If you are looking for a TZ Grip, you want the same shape as the TZ Grip, i.e. a thin, KnurlPatterned Grip.The detail is perfect.It's the skinny TZ Grip itself.But the..The Material of Rubber is not g...
After 8 months of use, today the Left SideMirror became wobbly and droopy.When I checked the Manufacturer, it was said that repair was not possible, so I cracked the Mirror part and confirmed it.The r...
The goal is to increase the ride height of your moped motorcycle! Also, the Center Stand no longer rubs when cornering!
Eight months of use, and today, Left SideMirror became lurid.When I checked the Manufacturer, it was said that repair was not possible, so I cracked the Mirror part and confirmed it.The reverse side o...
 |  |  |
| | | |
 |  |  |
| | | |
 |  |  |
| | | |
 |  | |
| | | |
 |  |  |
| | | |
I puncture at Touring last time and bought it for my friend to lend me for future on-board use.When you try it out, the thin tip makes it easy to insert it into the gap.It was easier to BEET up than t...
It is very easy to use and can be turned smoothly. The price is also reasonable and good value for money.
The spring is easy to handle when installing and removing the Full Exhaust System, and it is very useful to have because it reduces the risk of damaging the exhaust pipe and silencer.
I used this tool when I changed the Clutch on the Grom. With this tool I was able to lock and remove the center nut, which is a necessary tool for engineers.
I bought it to replace the Clutch of my beloved Honda GROM that I use to commute to work.
You can use what you can use for servicing Large type cars as well as 4mini.When dealing with the part where GEAR inevitably rotates, such as detachment of the Clutch basket, it is a sense of luck if ...
KITACO:NEOBore Up KitIncluded Parts:"Reinforced H-Beam Crankshaft. When the crankshaft is press-fitted into the crankshaft case, it is a tool that is necessary. In addition, it is a tool which is not ...
I bought it for FUSION. I liked the way that the original blinker relay can be inserted into blinkerWiring. Then, only the explanation of the Front side was written in the Instruction Manual? The text...
Wiring is a must-have item for race regulations, and although there is a small amount of wire in the package, I think it's better to buy the bottom type if you are still racing. I think these are freq...
It is used for both Oil and Coolantfor Replacement.I appreciate the part of the lid that prevents foreign objects from getting into the storage area. I think it's easy to use.
 |  |  |
| | | |
 |  |  |
| | | |
 | ||
| |
I bought the D-ring Fastener for better maintenance.As the product name suggests, the cowl can be removed with a one-touch operation, which leads to shorter maintenance times.The more areas that are h...
I used this as a reference to build the Bore Up Kit for APE. The kit that I purchased was Takekawa, but it was described in detail than the attached Manual, and it was very helpful.
Overnight touring gives you a greater sense of security to use in your accommodation.It's quite pricey, but it's the price for peace of mind.However, the drawback is that it is heavy. I think this is ...
Detailed Illustration and easy to understand.Easier to understand than the service manual.The differences between the spec. of the engine are also described.It is generally easy to use. It's not a bad...
I bought a new motorcycle and I'm having trouble getting power to the Navigation It was a good timeThe power supply was branched from Horn's power supply and installed successfully I hope it lasts as ...
We will learn how to disassemble and assemble the OEM parts as well as the 5-Gear's How to assemble the TuningParts, including assembly and installation of the Special Clutch The contents are diverse,...
You will learn how to disassemble and assemble the OEM Head as well as the Bore Up Kit Assembly, etc. of TuningParts, adjustment of ignition timing, carburetor The contents of the book cover a wide ra...
I bought it as a YZF-R25 Saiya Full Cowl RepairThe size is slightly different, a little short below the neck, but I managed to stop itAs far as Repair goes, it's helpful...but I can't deny that it's p...
I bought it for my new MotorcycleI was afraid of theft, so I took the plunge and went with this oneI've never seen such an expensive rock beforeIt would have been nice if there was a cover or somethin...
I have a W800, and even though I don't usually touch it myself much, it's easy and quick I was able to install itI have installed it directly to the Handlebar by passing Wiring underneath the Tank and...
 |  | |
| | |
On all the Motorcycles I've ridden recently, I've always put a Helmet holder in this position.So I bought and installed it on the for GPZ900R again.The CB400SB was the same, but with a motorcycle with...
Basically, I put the Helmet under the Seat, but if you go shopping or something, this holder is very useful.It was easy to installIt may not be a good idea to leave the Helmet attached to the Holder.
I was able to easily install and remove it from both the Jet and AGB Full face types of Bell and AGB with one touch. Apart from being a bit heavy, it's well worth buying.
It is easy to install and fits perfectly because it is only for ADV150This motorcycle has a small Helmet in, so it's hard to store the Helmet since things tend to happenThe Helmet holder is very usefu...
The helmet holder is in the Rear Sets, but to be honest, it is difficult to use, so I bought it It wasIt takes a little bit of effort to support it because it is sandwiched between the Frame and Tande...
In the GSX250R and NINJA, you can remove the Tandem seat and use the Seat lock It's a way of securing a helmetIn Touring and so on, you can't use it if you put a Back on it, it's going to be a Large w...
Matching CB250R for printing (MC52) is the CBR205RR in the photo (MC51) You will see and feel uneasyI don't know how it feels to install it as I haven't installed it yet, but it will be installed as p...
The Helmet holder on the back of the OEM Seat is completely uselessI'd love to see this one adopted as an OEMIt opens from the top when you unlock itNot applicable, but I have it on my MT-03
I'm using it on my MONKEY125 (OEM is too deep because it's assumed to use auxiliary wire)Clutch lever attached to the side, because the Handlebar Lock cuts to Left It's a hindrance, but it's also a ha...
This product uses two bolts which are holding the tandem seat footrest. These bolts are really stubborn so you might need some equipment for that. And if you once loosen them you better use some Threa...
To continue viewing this product on Japan domestic webike (in Japanese), press "Go to Japan Domestic".
?
* The BEST and MUST store to find Japanese parts.
* Register now for amazing deals and other special offers!
* Over 800,000 listed items. It's hard NOT to find your parts.
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
About our "Mybike" service 
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING