Yüksek parlaklık LED X 24
[Ürün İçeriği]
1. LED özelleştirme Zing kurulu Sıralı typeAssy
Ön / Arka flaşör 2-telli Tip 120 derece Pin tipi 4 adet
2. Sıkma vida M3X30 4 adet
3. plastik spacer 4 adet
4. Naylon yıkayıcı için 4 adet dokunarak
* Yanıp sönme döngüsü LED gösterge dönüş sinyali rölesiyle bile uyuşmuyorsa, normal çalışmaz. CF POSH şirketi için ayrı olarak satın alınan konektör, ayrıca gösterge rölesi değişimi gereklidir.
* Yolcu muayenesi kabul / reddi kriterlerine uymakla birlikte, mevcut durumda yolcu muayenesi kabul / ret kararının sarsılmış denetleme memuruna bırakılacağını lütfen unutmayın.
High luminosity LED x 24pcs
[Kit Contents]
1. LED customizing board sequential type assy
For front and rear blinkers / 2-wire 120° Pin Type........ 4pcs
2.Tapping screw M3 x 30 4pcs
3. Plastic spacer 4pcs
4. Nylon Washer for Tapping 4pcs
*If the flashing cycle is not compatible with the LED blinker relay, it will not work properly.CF POSH blinker relays must be purchased separately and the blinker relays must be replaced.
*There may be changes in product specifications due to the manufacturer's reasons.
■□■Regarding Sequential blinker specifications■□■
1. cycle 1sec-0.5sec
(More than 60 times per minute and less than 120 times per minute / Product flashes 73-75 times per minute)
2. the following conditions must be met when flashing light sources are produced by chain lighting
(1) Each light source remains lit until the end of the ON cycle after it is turned on.
(2) The lighting of the series of light sources occurs uniformly and progressively from the inner to the outer edge of the apparent surface.
(3) No repetitive alternation in the vertical direction (e.g: A single continuous line (without waves).
(4) The variation ends within 200ms after the start of the ON cycle.